Contact - Mosquipro

Supplementary Z Guide

If your window does not have an upper and lower track for the mosquito net to slide, we offer a guide to place at the top and bottom. In this case, you should install the guides so that the resulting measurement from edge to edge (where the mosquito net will slide) is exactly the height you provided us to manufacture the mosquito net. Please note that each guide profile has a height of 24mm.

INSERT THE DRAUGHT EXCLUDER

RAMP PROFILE

Actuation

Type of Fastening

How to measure

For the width, measure the total width of one of the window panes (approximately half the width of the opening).

For the height, you must take a measurement. from inferior nerve to superior nerve where the mosquito net will run. We will take care of the necessary adjustments so that the mosquito net fits that measurement. If you are going to install a supplementary "Z guide", bear in mind that each guide has a total height of 24mm and you will be installing one at the top and one at the bottom..

How to measure

Measure the width at 3 points (top, middle, and bottom) and use ALWAYS the smallest measurement. If at any point the measurement is lower, use that measurement.

Measure the height at 2 points (right and left) and take ALWAYS the smallest measure.